Discussion Locked

regarding bandwidth

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
can we manipulate the bandwidth in the cisco router which is coming into it,when it is diverted to other network?

3 replies

by mshavrov

The short answer is YES. But you have to be more specific. First, answer to yourself, what do you want?

* Limit the bandwidth for particular applications?
* Limit bandwidth for specific users?
* Get some traffic higher priority than other traffic?
* Is it inbound traffic or outbound?
* Should it be just a local limitation or it should be through your network?
* If it's Internet traffic, does your provider supports this limitations/prioritization?
* What amount of traffic you are talking about?
* What if traffic comes at higher rate than you expect, is it OK to drop the exceeding traffic?
... etc.

For basic information, look for "QoS" term - traffic management is part of the "Quality of Service" suite. Look at the Cisco website for "QoS" to get all information required. Or hire consultant. :-)

Good luck,

Michael Shavrov
CCNP, CCDP, CCSP, MCSE W2K, Security+, etc.
http://www.ciscoheadsetadapter.com

by jwxt

Vaguely. I want to limit bandwidth coming in and out from the switch to my router. (on the Router) what must be done. I have been reading up on MTU and MSS, but unsure quite how to make the router config changes.

This discussion is closed to new replies.