Discussion Locked

Relocating network

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We are relocating and the building where we go has already network wiring but they are running Ethernet and we have Token Ring. Funny I never thought about these before, but can I, by any chance use the existing wiring instead of doing it from zero ? (The wires looks the same, the plugs are the same so I'm wondering!)

9 replies

by sgraham

There are three major physical token ring cabling systems: Shielded Twisted Pair (STP), Unshielded Twisted Pair (UTP), and optic fiber.
If the cable in your new location is either of the above, then you should be able to reuse it for your Token Ring network. It sounds like you are using an RJ-45 connector, which has an eight wire twisted pair cable:

Pin 3 - Blue/White - Transmit -
Pin 4 - White/Orange - Receive +
Pin 5 - Orange/White - Receive -
Pin 6 - White/Blue - Transmit +

I would recommend that you recable, as no one likes to deal with someone else's problems, which might be exactly what you get if you reuse the cable.

by themain

as long as the wire is cat-5 you will do fine . if you want to stay with token ring you will have to transplant the 'hubs' for token ring to the new building. token ring works fine. i've seen it up next to 10 megabit switched eternet and atm. tokenwas solid as rock. this is a room with 160 computers and two classes with 20 each. the atm was better than we have now, but that is due to our network manager's paranoia. he alone has ruined our ethernet network by choking the network at the firewall and 'learn as you go attitude'. get good consulting and don't cramp the budget on the managing team.
if speed is your future concern toss your hubs and go to switched ethernet, 100 megabit with gigabit backbone.
change over slowly, as in any project, try to disrupt everyday business as little as possible.

by highlander718

Thanks ! The real issue actually is exactly the time. The change will take place in one weekend, so I have to move servers, cabling, workstations ..everything .

by jpt

One word of caution if you want to reuse existing cabling. If something goes wrong on your network, it may be due to the wiring. Unless you can get the warrenty from the last tenents or you're confortable with the cables and it isn't an issue, ignore this message.

by gbworld

The wiring for the Ethernet should not pose any problems for you. It has been awhile since I have touched token ring, so I am not 100% sure if the connectors are compatible. However, replacing connectors is not as big a deal as replacing wiring.

Token ring standards are actually a bit lower than ethernet and both will use twisted pair. You probably have at least cat5 in the walls, so you will be fine.

Gregory A. Beamer
MCP: +I, SE, SD, DBA

by highlander718

Thanks, I think though that I have to give the points to the previous guys
as you answer is somehow included there.

This discussion is closed to new replies.