Discussion Locked

Remote access Netware 5.0 server

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I would like to allow 10 of my collegues to remotely access an Netware 5 server. My collegues carry notebooks with PC Bus/ PC card modems of mixed brands. I have a US Robotic 56K Faxmodem connected to my Netware 5 server and Netware Connect 2,0 running on it. I discovered that this setup does not work very well as not all PC bus/ PC card modem is able to dial-in successfully. I need a solution that will give me 100% successful dial-in and maybe a not too expensive alternative that will give me better data transfer speed. Security must be taken into consideration.

Advise please.
Thank you.

5 replies

by jackie d.t.

First, what protocols are configured on your NetWare 5.1 server? Is it IP with Compatibility Mode? IPX? Or do you have both IPX and IP installed?

If your server is configured for IP, you have no problem, but you need to install the NetWare Client on the remote workstations and configure than per instructions below. And it works with a dialin connection.

Load SLPDA.NLM (Directory Agent) on the server. If you load the SLPDA, clients can communicate via unicast or multicast. Accept the default configuration for the SLPDA.

Next, configure the NetWare Client on the workstations, and be sure to add the IP address of the server in the Directory Agent box under the Service Location tab of the NetWare client.

Let me know how you make out.

by giamtw

IPX is configured on the sever. Is there another solution other than configuring IP on my server?

Thank you.

by giamtw

IPX is configured on my Netware 5 server. Is there a another reliable solution other than configuring IP on the server? Thank you.

by jackie d.t.

Hi,

You can test using IPX, I do not think it will work but I am not sure. In my enviroment IP is dominant. Drawing on my past experience, users needed to dialin to a remote workstation to access the server using IPX.

Let me know how you make out with IPX and logging in remotely.

Jackie

The best route would be to install IP.

by giamtw

I have spoken to 2 system integrators.

One solution proposed is to install Digi Datafire RAS 4 in the server and subscribe to an ISDN line to give me faster connection. This allows for analog/ISDN remote dial-in.

It is not a must that I cater for more than 1 dial-in session. Ability to support 2 concurrent dial-in session is already a plus.

The other integrator suggested using a CISCO router plus some other stuff, have not got details yet.

This discussion is closed to new replies.