Discussion Locked

remote access service

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

when i configure ras on win nt server and dial from a client (win95) modem on the server gives the hash tone but ring continue
on client system when i re start the ras on server sometimes it gives the error "1066"

2 replies

by cagandhi

Hi,
the first thing is after installing RAS service reinstall the NT SP 4 or the latest version of the Service pack of nt 4.0

Give Dial in permission to the specific user Also configure the RAS port to dial in & dial out
Use any or clear text authentication at the client side.
If want to do something new, Install the RRAS " Routing & RAS" on the nt.
but after that again u have to install NT SP 4.0 or latest which u have previously installed.
If DHCP is not installed on the server then configure Static pull in the RAS or set static ip of ppp adeptor on the client pc.
Installation of the servicepack is the most imp. thing.
good luck.

This discussion is closed to new replies.