Discussion Locked

Remove an unknown object from NDS tree?

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When old 4.11 server crashed, it left an unknown object in the tree (DSS1_SYS)the old server volume. It is still in the tree and when I brought up a new server, that object interferes with the new server volume. IT says I do not have enough rightsto delete it. I have tried every Novell utility and they will not touch it or refuse to write the corrections to the tree when finished.
Any ideas or how can I edit the volume properties to remedy this?

11 replies

by dle

Have you tried using DSRepair to fix the problem with the unknown volume object? If that does not fix the problem, then use NetAdmin from the DOS prompt to remove the object.

by rbgnr111

dle is right.
run dsrepair,
then use netadmin or netware administrator to remove the object.
make sure the user you use to delete the object has supervisor rights.

by wcraigmiles

Novell used to recommend using an older version of NWAdmin, without any snap-ins, when removing unknown objects. If you can see what effective rights you have from the NWAdmin utility open your object and go to right to files and directories. You may have to login as Admin to delete the object. Sometime critical objects will not honor the security equal to value.

Another trick is to load dsrepair at the server with the -a switch. This switch opens several other menu items not normally available under dsrepair. There is an option for removing unknow objects. Also, be sure your current server is not named the same as the crashed server and that the sys vol is notnamed the same. This might be the root cause of the conflict if it thinks you are trying to delete an object that is still active.

by estebandelatorre

RUN an unattendant Full repair using dsrepair.nlm and then you will be able to remove the object. Be sure to have admin rights to the object.

Good luck

This discussion is closed to new replies.