Discussion Locked

Removing 4.10 server from NDS tree

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We have 2 offices, California and Texas. Our
NDS was running over an older point to point
WAN link using IPX routing. Recently we upgraded to a frame circuit, routing ONLY
tcp/ip. Texas' novell server needs to be removed from my NDS tree in california, but I haven't found a way to do it. From all I have seen in NWadmin and NDSmgr, I need the server in TX communicating over an IPX routed wan link. Any way to remove a server
without being able to talk to it over the wan?

13 replies

by troyerj

Have some questions and then I think I can help you.
1. Do you still have a tree in Texas? If so, same as the one in California?
2. Where is the Master replica for the partition these servers were in, California or Texas?
You can email me or post the answers here

by dshade

The two servers MUST be able to communicate to remove the TX server. Two options:

1. route ipx over frame, remove server from tree then turn of ipx routing.

2.Ship the TX server to CA remove it from the tree. Install it in a new tree, Howerverall the objects must be recreated in this new tree.

by rws

There are some "brute force" methods you can use to remove the server from the tree. The best practices method is described in Novell TID #10010922 available at support.novell.com

Hope it helps.

by papachuck

Two thoughts....1. use VPN to connect between the two servers. You can tunnel IPX through IP in this case then do your purging at that time. Complicated solution...2 Prepare a machine with PC anywhere then call Novell Tech support. They can remove the server from NDS over a dail up connection...simpler solution. (they did this when we had a NDS crash).......Good Luck....Chuck

by papachuck

Two thoughts....1. use VPN to connect between the two servers. You can tunnel IPX through IP in this case then do your purging at that time. Complicated solution...2 Prepare a machine with PC anywhere then call Novell Tech support. They can remove the server from NDS over a dail up connection...simpler solution. (they did this when we had a NDS crash).......Good Luck....Chuck

by papachuck

I can think of two solutions one complicated one simple.

Complicated. Install a VPN between both offices and tunnel IPX through IP then delete the server after syncing up.

Simple. Call Novell Tech Support they can delete the server over a PCAnywhere connection to your network. (they had to do the same when we had a NDS crash a few weeks ago....) Good Luck......Chuck

This discussion is closed to new replies.