Question Locked

Repair Dell Lattitude D600 ower jack

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I need to repair Dell D600 power jack
Removed main board using instruction from Dells website.
The metal frame is still attached on the bottom and there is a metal plate that is over the powerjack on to which is part of the chip cooler
How do I remove these to get at the power jack

2 replies

by mjd420nova

These frames are usually soldered to the board. CAre must be taken in removal and excess heat needs to get limited and still hot enough the melt a large pool of solder and such it up or wick it away. Care is essential you not pry or overheat because the traces will seperate from the board.

This discussion is closed to new replies.