Question Locked

Replace PERC/CERC RAID Controller on Poweredge 1800

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,

I had to replace the Raid controller in my Poweredge 1800 Server running 2003 server, and now when I boot up it says "no boot device available, strike f1 to retry boot, f2 for setup utility"

It shows that I have 1 logical drive found on host adapter.

"CERC ATA100/4ch RAID Controller Bios ver 1.03 Jun 10, 2002"

"PERC/CERC Bios configuration utility Ver5a42 Jan 21 2002"

Any ideas that might help?

5 replies

by oh smeg

Did you use the same make & Model Card?

if not you need to reinstall the OS along with the Raid Driver.

Col

by chad969

Yes, It is the same Make and Model of card. I am trying to save the data I have on the drives, so if I reloaded the OS, I would overwrite the data... right?

by seanferd

That won't overwrite anything but the OS files.

by w-squared

Even though it's the same card it must be setup like the old one. Get into the bios of the card and check the setting for drive(s) and any RAIDS that were set.

This discussion is closed to new replies.