Discussion Locked

Replacing NETWARE compliant

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have inherited a network configuration where a Windows 95 station needs to communicate with a Netware 3.76 server.
Two NICs are present on the Windows 95 station; one is NETWARE 2000 compliant the other isn't but has the IPX/SPX protocol bound toit. As the two cards are connected to the same physical network I need to disconnect one of them (loops are no-no on Ethernet). If I choose to disconnect the NETWARE 2000 compliant card will the non compliant NIC with IPX/SPX installed ensure all communications with the Netware 3.76 server.

If this is a viable solution what pitfalls do I have to look out for?
If a better solution exists can anyone suggest to me what it is?

Thank you

1 reply

by dnsb

Perhaps a typo there since there is no Netware 3.76. Otherwise, the "Netware 2000" compliant NIC is most likely an old NE2000 NIC which can probably be removed.

f you are running a Netware 3.xx or 4.xx network, you just need a NIC with IPX/SPX and the Novell client. After Windows 95 has installed the NIC, installing the Novell client (3.32 is the latest version AFAIK)should be all that you need to do. If you are running NW 5.x or 6, you can use IP or IPX as the base networking protocol. IP is often the simpler way to go to simplify your router setups.

Regards,

This discussion is closed to new replies.