Question Locked
0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My company purchased a company who used SCO Openserver on a HP Proliant ML350 G4p. I would like to reconfigure this server with Windows 2003 however I can't figure out how to complete this task. I have tried using a HP SmartStart CD veersions 8.30 & 8.50 for Windows however it continues to boot to a command prompt. I even tried deleting the logical drive partition and creating a new one. Can anyone assist me? Thanks
4 replies
by wsaparts Accepted solution
Clarifications
by robo_dev Accepted solution
If you run FDISK, you should be able to see the partitions and see which one is marked Active. You may need to fiddle with bootcfg as well. See the KB link below:
http://support.microsoft.com/kb/315261
I assume that Windows installed properly without errors?
by wsaparts Accepted solution
Thanks for the reply. That's the problem. The server has SCO Openserver installed. I want to switch it over to Windows. I was wondering if I could just install Windows on top of the SCO? When the server boots currently it goes to a command line. I don't know SCO OpenServer.
by robo_dev Accepted solution
Sure, you just reformat the volume and reinstall Windows from scratch.
The only tricky part may be that the RAID controller drivers may need to be loaded from a separate floppy or CD when you go to install Windows.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies