Discussion Locked

Resource conflicts within NT4.0

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have installed NT 4.0 onto a machine and cannot get the NIC to work now. Keeps coming back with a resource conflict. I have uninstalled/reinstalled the card into different slots with the same results. The display adapter is not listed either and cannot get the driver to load from disk. Any suggestions?

3 replies

by ed spencer

To accurately resolve this problem more information is needed. Type of machine, other installed peripherals, type of NIC, etc. But you can do a few things to help you on your way...

Start with WINMSD under NT. Take a look at the resources and see if you can find a conflict. Turn off Plug and Play in the BIOS. Specify the IRQ's to be used for the PCI slots in the BIOS. Turn off peripherals you won't be needing under NT 4.0 (USB, IR, etc.) With all the devices that are on machines it's not that hard to find yourself short of IRQ's (Which is where I would guess that your conflict is.)

I don't know if this will help, but it may help you at least get started in resolving your problems. If you post additional information I'll try to provide additional assistance.

by august55

Where do I start WINMSD under NT? I looked under PCI Config in the BIOS and all the IRQs say "available". This pc is a HP Pavillion 6630 that ran 98SE on it. I wiped it clean and installed NT4.0 which went ok and the 3Com Office Connect FastEthernet 10/100 NIC installed ok it said. It won't connect or ping because of a "resource conflict - change in the BIOS or upgrade the BIOS". This is where I am stumped since I am not familiar with the NT machines. Also, if it makes a difference I kept the FAT instead of changing the platform to NTFS. Thanks.

by fketter

Go to START then RUN and type in WINMSD ( this does not have to be Caps). This will bring up the Windows NT Diagnostics window.

This discussion is closed to new replies.