Discussion Locked

Restricting net in school with no server

0 helpful
16 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have been asked to set up a network for a small private school being started (Small budget). We want to provide internet access but only to a few selected sites. At work we do that using MS Proxy Server 2.0. However, at the school I was planning on a peer-to-peer network with no server. Any ideas how to acomplish this with a peer-to-peer network?

16 replies

by bert bolin

To be honest the best way to accomplish
this is to use some sort of proxy server.
Now you can find some cheaper
alternatives to MS Proxy Server. What
operating system will the peers be
using? For instance, many schools use
Macs, and there is an inexpensive
solution called Vicom SoftRouter that
includes an application to control access
to websites. It cost $249.00. There are
similiar products for other operating
systems. Most likely using one of your
peers that you can set aside and run
such a program on, will be the best
method in terms of cost effectiveness.

by Former member

You could hook up those selected sites with a simple web sharing device such as a "Web Beetle" or 3Com INternet Sharing modem/hub.

by a h

Hi

Use the Internet Explorer Content settings

Internet Explorer > Tools menu > Internet Options > Content > Enable Content advisor
Set a password so users can not change the settings

Then on ?Approved Sites tab? enter the sites that you want to allow

Make sure that on ?General Tab? users can see sites that have no ratings is ?not checked?

Look around the settings for more options you can set

If you need information on setting the network itself on a small budget
Visit this site (It is a good one):
http://pcmech.com/byonet/index.htm

Good Luck

by strong002

If it is a small flat network you could set it up using netbuei on all the workstations to talk locally and install TCP/IP on the workstations that you want to have access to the netowrk.

by strong002

If it is a small flat network you could set it up using netbuei on all the workstations to talk locally and install TCP/IP on the workstations that you want to have access to the network.

by jackieb

OK, here goes. I don't have all the info needed but I will take a stab at it.

First: Set up your machines all with hardcoded ip addresses, using addresses in the 10.x.x.x range so that they will not be routed to internet (the router will not pass packets with a 10.x.x.x address).
Second: two options:
One- Set up a NAT adress translater to act as a proxy and enable only those adresses you want to have internet address. or
Two- Use a real internet address (IP) for the machines you want tohave access the internet. If you want to talk between these machines and the other, non-internet machines, you will have to have something acting as a bridge between the two networks or have a second interface on those machines configured with an address on the 10.x.x.x network.

This should be a viable solution for you. Good Luck, JackieB

by tbradley

if you're using dialup, the answer is elegant, cheap, and easy. Buy a 3com Lan/modem, which provides 4 ethernet ports and 1 or 2 56k dialup modems. This will connect to an existing ethernet network, and will allow you to set proxy setting, as well as designate acceptable workstations. Not a whole lot of security, as acceptable WS's are allowed based on Machine name in Network Neighborhood, but for $139 dollars, what do you expect.

This discussion is closed to new replies.