Discussion Locked
0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Is there a way to show only one connection per user in the NetWare send message box, so that users do not receive multiple messages?
8 replies
by trekdude
Point value changed by question poster.
by tchoukavine
The syntax of command at server console is:
SEND message [[TO] username |connection number ] [[AND|,] username |connection number ]
So you can send msg to user1,user2,... as follows:
SEND msg user1,user2,...
At a workstation on NDS server you can use a groupname or servername instead of username.
Sasha.
by trekdude
Poster rated this answer
by wcraigmiles
If you are doing it from a workstation, there is a send function that will only send it once per user. Look at client32, right click the N in the tray and you'll see Network utilities. Near the top is the send message function. Try it you'll likeit better than the server version.
by trekdude
Poster rated this answer
by pierrejamme
If you are using an older client you get two messages when you click the OK button after send. Press Send and read what the next screen says "Message sent". So close out by hitting the X, instead of OK. Or even better yet upgrade to client 3.3, you will need to when you go to NetWare 5.1 anyway.
by trekdude
Poster rated this answer
by trekdude
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies