Discussion Locked

RIS Install of W2K Profession

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to install win2k pro on a new cleint that has all of the requirements as per microsoft. The RIS server seems to be configured correctly with the profession CD image installed. The problem happens after I boot the cleint and get and IP address from the server. It goes through user name and password ok. It says it is going to delete everything on the hard drive. It then scans for hardware and ask you to press f6 for scsi and raid, which I don't have or do. It gives be the globalID and on the next screen it gives me this error:
WINDOWS 2000 Setup
--------------------
The operating system image you selected does not contain the files for your network adapter. Tryp selecting a different operating system image or see your network administrator. Well I am the network administrator and I don't know what the heck to do. What gives, please help.

3 replies

by wnelson

You mention that you are using all the correct requirements as per Microsoft. What NIC are you using? Have your DHCP server and RIS server been authorized? In Windows 2000, DHCP and RIS must both be authorized using the DHCP Management Console (Start->Programs->Administrative Tools->DHCP). Right Click and Authorize or Manage Servers and Authorize.

I have also been successful using the following after EVERY little change I make to the RIS service

net stop binlsvc
and then
net start binlsvc

In addition to this info, check out the book

Inside Windows 2000 Server by New Riders - or
Mastering Windows 2000 Server by Sybex

both have a nice section on RIS

Hope this helps.

Will Nelson
wnelson@gcsisolutions.com

by nojunkmail

The RIS server has been authorized and DHCP is giving the client the address. It actually starts the install, until it gets to that screen. The nic is an intergrated Intel Pro 100. It is on the list as a supported nic.

by markberry

I am also having the same problem. I had the Intel Pro 100+ nics and the installation worked fine. The new Intel nics are slightly different, we are now getting Pro 100s, and the RIS installation no longer works and gives the same messages you are describing.
Try the Microsoft Knowledgebase article (Q246184) titled "How to Add Third-Party OEM Network Adapters to RIS Installations" available at:
support.microsoft.com/support/kb

I would be very interested to know if you can get this to work as I have so far been unsuccessfull.

I have also tried following the info on how to this included in Intels latest driver download. I have also been unsuccessfull with this.

This discussion is closed to new replies.