Discussion Locked

Rookie Needing Easy Advice

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I've acquired the use of a Cisco 2524 router while studying for the CCNA. I've established the serial-to-console connection to practice configurations but I'm unable to back up the IOS to my PC. I've got the TFTP software but I'm unable to ping myPC from within a Hyperterminal session.(not sure if that's possible anyway) I configured the Ethernet 0 port and it shows that it's up and I'm using a crossover cable from that port to my NIC. I know the NIC is good and I'm also able to ping the NIC from a DOS prompt. I can't ping the Ethernet 0 port from a DOS prompt nor can I Telnet into that port. I'm running Win98 and the NIC has a class B address with a 255.255.0.0 mask specified. The Gateway is that of the Ethernet 0 port. I hope this is enough information to come to a conclusion. Given my current rookie status you can probably understand why I want to have the IOS backed up. Thanks.

Dave

7 replies

by stillatit

In order for you to ping your PC from a router hyperterminal session, or use TFTP, the PC's NIC and the router's port must be on the same physical network, and must have the same network numbers.

You said the NIC on your PC has a class B address.That means that if your address is a.b.c.d, then a.b is the network number and c.d is the node number. In order for your PC to talk to the router, the router's Ethernet 0 port must have an address starting with the same a.b network number.

Good luck.

by azdavid99

I knew it was something I knew about but was just having a brainfart. Thanks, worked like a charm once I changed the NIC's IP address accordingly.

by mckaytech

Since the router shows the Ethernet interface is up, your cabling is probably okay. I assume you also have a link light on the Win98 end. But it sure sounds like either a physical (Layer 1) problem or an addressing problem and it sounds like an excellent situation in which to start learning troubleshooting :-)

The only suggestion I can make is to look at the address and subnet mask on each end one more time and you might also want to try a default gateway on the router.

Otherwise, you can still backup the configuration by doing a Hyperterminal capture and then 'sh conf' (start the capture just before you enter the 'sh conf' and stop it just after). In case of disaster, you can clear the NVRAM and use the Hyperterminal "Send file" function to send the configuration information back to the router. I also have software that allows me to back up router configurations to my Palm through the serial port and then re-load if necessary. You'll definitely want to get the Ethernet interface working, but in the interim, these are some other options for saving the configuration.

Also, if you'd like me to take a look at the config for any potential problems, you could send the file you saved through Hyperterminal.

paul

This discussion is closed to new replies.