Discussion Locked

RunNCF file from a Remote NetwareServer

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Netware 4.11 server that is running ARCserveIT. It backs up a Netware 3.20 server. I need to stop InoculanIT during backup because
it seems to slow the backup down when we leave it up. I went into the configuration for the backup and added PRE/POST commands as follows

PRE
\\servername\sys:system\istop4

POST
\\servername\sys:system\istart4

both commands fail with the following error

??? Unknown Command ???

is my command syntax correct or is this even possible?

9 replies

by tbradley

wouldn't unload Inoculanit.nlm and load inoculanit.nlm work better? Simply starting and stopping does not stop all the processes.

I'm not familiar with Inoculanit, but am with an earlier version, Inoculan v4, and the stop command did not stop, nor unload the core NLM's.

by tlb

I use ISTOP4 and ISTART4 on my system, it works fine, but I'm not performing it on a remote server.
I believe that you don't need the path, just put it in the pre/post for that server and not the entire job. That way, that server will just issue those commands, just like your at the system console prompt.

by acurrin

Why not use a timer NLM on the remote server to shut the Innoculan down for a period of time that would cover the backup and start it again sometime before the workday starts?

Let me know if you need suggestions for an NLM and I'll track one down.

This discussion is closed to new replies.