Discussion Locked

Running NCF's remotely

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Is it possible to launch an NCF from a remote workstation? Through a command prompt, batch file or otherwise, on a Windows box? If so, what is the proper syntax. I need to stop Groupwise and Netshield prior to running a backup using the ArcServerNetware Agent.

Thanks,
Brian

5 replies

by jaolson40

by tbradley

in your autoexec.ncf file, make sure you have a line for remote. At the server console, load nwconfig for NW5 and load install for 4.11

look for the following line, or create one
( if you create one, you will have to manually load this in the server console after you edit it in. It'll start auto the next time the server is rebooted.

load remote xxxxxxx ( where xxxxx is the password you want )

Now, there are 2 ways to connect via remote, a dos based version via IPX, and a gui interface via tcpip.

The dos based is called rconsole, and is in the public directory on the server.

The gui based is called Rconj, and is in the
\public\mgmt\1.2c directory

At your windows workstation, you'll be able to connect and run any commands you want at the server console.

My question, in your arcServer startup file, you should be able to script GW and NS unloads, and then restarts after the backup.

This discussion is closed to new replies.