Question Locked

Running out of IPs

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hey everyone,

I'm running out of IPs on my network (using 192.168.1.0) and I was wondering if I can easily add the 192.168.2.0 network and still have communications on the same domain (e.g. fabrikam.local). Is this possible, or do I need to create a new domain also?

I have a server in mind to use as a router if that is possible also. Any other suggestions would be appreciated.

If you guys need other information, just ask.

8 replies

by scott_heath

You can use as many networks as you like. We have dozens where I work. You just need to make sure your route table is configured right. You can use OSPF or RIP most likelt, or since it is a small network just enter a static route. Although I suggest you invest in a router and not use Windows RRAS.

by powlboyjr

Thanks for the information. I hope to convince the boss on a router in the near future. Also, if I am using the server as a router temporarily, how would I configure the IP address? Currently here are the settings:

LAN Connection 1:
IP Address - 192.168.1.46
Subnet - 255.255.255.0
Default Gateway - 192.168.1.1

Primary DNS - 192.168.1.46 (Itself)
Secondary DNS - 192.168.1.47

LAN Connection 2:
IP Address - Automatic
DNS - Automatic

Again, thanks for your help.

by scott_heath

By change the mask you go from a class C to class B network with way more available addresses. You should be able to use your existing router to do this.

by Former member

You can simply re-mask your clients and servers (in place of the 255.255.255.0) to the following:

Mask 255.255.0.0 - You can then use 192.168.0.1-192.168.255.254 (boatloads of addresses)

or

255.255.254.0 - You can then use 192.168.0.1-192.168.1.254 (510 addresses)

by powlboyjr

This sounds like a good idea. The only hard part on our end is we have not implemented DHCP, so, being the underdog, I'll be the one running around to every workstation. Now would sound like a perfect time to persuade the boss to look at DHCP, haha. The only reservations he has there is that we won't be able to block certain computers from the internet, but I've told him our firewall can handle that. Thank you for your input.

by powlboyjr

I'm confused. If some computers have a 192.168.2.x address, they won't be able to communicate with 192.168.1.x even if they are on the same subnet (255.255.254.0), will they?

Also, what will the default gateway be?

by thumbsup2

Q said "255.255.254.0 - You can then use 192.168.0.1-192.168.1.254 (510 addresses)"

So, 192.168.0.x will be able to communicate with 192.168.1.x BUT not 192.168.2.x

You would need to reassign IP's for everyone using the 2.x IP range.

This discussion is closed to new replies.