Discussion Locked

running scandisk and defragmenter

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Whenever I run scandisk or defragmenter in Windows 98,they run for some time ,then start from the begining once again and run for more time than in the fist instance,like this they keep on going.Thereby wasting a lot of time.
Please advice what is wrong and how to make them run continuously till completion.
Thanks.

13 replies

by ann777

What makes them start over? Any type of disk activity... an antivirus program, an e-mail receipt... etc.

Remove all programs that you do not need running from Task Manager, then start your scandisk or defrag.

by mm212

Both of these programs will restart when a program writes to the disk being scanned/defragged. The good news it that the scan/defrag actually picks up where it left off. Yes it does take a little longer, but usually not too bad.

What will help isto do a CTL-ALT-DEL and do an "End Task" on every program except for Explorer and Systray.

by cyberstoner

Make sure you don't have any other programs running in the background while using scandisk or defrag. It's tying to read your drive(s) at the same time that "another" program is reading/writing to the same drive. So scan/defrag has to start over once the "other" program stops accessing the HD.

by tamj123

this nomrally cause by Virus Program such as Norton and Macfee. Stop or disable the Virus Program before you run the scandisk and defragment software.

by troubleshootergurl

Its my guess that you have the Norton Antivirus Program running on your machine and is causing the Disk Defrag to restart over and over. Norton and other programs are constantly running, so you may want to do the following to run a defrag or Scan Disk:

Go to start, programs, accessories, system tools and select system information and go to the tools menu and select "system configuration utility." Select the "startup" tab and uncheck everything that is in the startup menu, be sure to selectapply and click okay when finished. Unchecking all the running programs will cause your system to reboot. When the reboot is complete, run your disk defrag or scan disk.

When your defrag is complete make sure you select all of the items that were in the startup.

Good luck with that one! I am positive that will help you.

by admin-stuart

Restart your PC in Safe Mode by pressing the F8 key during startup, and selecting Safe Mode (item 3)in the startup list. When finished booting, go to display properties, set background and screen saver both to "None", then run your scandisk and defrag. Should run without multiple restarts.

This discussion is closed to new replies.