Question Locked

Running Server 2003 on GX280 - Driver ?

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello all!

I'm working on my 2003 MCAA and I want to build a cheap server box. I work with Dell OptiPlex GX280s at my current office and want to purchase a referb from eBay to setup as a sever at home.

My concern is that if I install server on this PC the NIC won't work. Will XP drivers work with Server 03? I checked Broadcom's site and they do not have drivers for the NIC for server 03.

If the on board isn't supported - my thoughts are that I would purchase a seperate NIC that had 03 support. Any thoughts on this issue or perhaps other concerns that may pop up trying to make this work?

Thanks!

8 replies

by larryd4

I have installed Server 2K on a 280, we have a lot of them, and it worked fine. But my guess is you will need to get another nic card for Server 2003.

You could try though, worst case scenario, you install it and if it doesn't work, you install the new nic later.

by willcomp

Yes. XP and Server 2003 use the same drivers.

by gcollier

Thanks for the replies! That's what I need to know. :)

by larryd4

Not all Dell Drivers from XP work with 2003, you may have to install a NIC card with it after all.

by larryd4

Many drivers that claim to be WinXP compliant are not. Especially the drivers from the first distro of XP. Their was such a rush to get the drives out they used many "shortcuts" to get the job done. This happened a lot with the Dell Drivers for their boards.

Its never black and white with technology..

by larryd4

As long as it has a valid Win2003 drivers and you have the GX280 Tower and not the small form factor it should be fine.

This discussion is closed to new replies.