Discussion Locked

Serial mouse during unattended setup

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I have a problem, I install my NT system unattend.
I have a PS/2 mouse connected, and a serial coonection to the UPS.
When I install NT everything goes well, all the apps go on, no problem.
The mouse (PS/2) works as well.
When I then try to install the UPS software, everything goes well, but when I reboot, the system comes in NT with a message that a new device is found, a PS/2 mouse.

I can resolve this by changing the value manually in the control panel under the mouse section.
This is no solution for the unattended setup.

How can I resolve this?

Thanks ina dvance,

Eduard de Vries
edevries@footlocker.com

4 replies

by guy

Try editing your boot.ini file. First remove the read only attibute (with explorer properties). Then add the following switch to each line /noserialmice
or you can use /noserialmice=comx e.g. com1
it should look like this:
multi(0)disk(0)rdisk(0)partition(1)\WINNT="Windows NT Workstation
Version 4.0" /NoSerialMice

by vance

I had a similar problem and found that the
mouse was at fault (logitech) When I changed to a microsoft intelli mouse the problem went away.

This discussion is closed to new replies.