Discussion Locked
0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am running NT server 4.0 sp5 on a P166 with a serial mouse. We haven't had any problems with it until yesterday. We had to restart the machine, and ever since it has not been loading the mouse. I went into event viewer and see the following notices: 1. from service control manager: The following boot start or system start drivers failed to load: Mouclass, sermouse. 2. from Mouclass: Could not locate the device object for one or more pointer port devices. I tried different mice, different drivers (it was just serial mouse, and I tried microsoft serial mouse). And have rebooted several times with no difference. I don't know of any changes we made that might affect it. This machine runs our tape backup but is otherwise not usedvery much. Thank you for your help.
4 replies
by dmiles
Unplug the mouse and reinstall through the add new hardware and select the generic mouse driver from pane,then up date the driver through the Device manager pane.
by seadogs
by jewright
From the desktop,,
CTRL&ESC will open the start menu..
R will put you in the Run box, press enter..
Type "WinMSD" then enter..
Make sure that the serial ports are installed and using the right resources..
Com1 Int4 3f8
Com2 Int3 2f8(Dont use a serial mouse on COM3 or higher)
If they are there, go into your Ports control panel applet and remove them both. If you only have one port you have half the work. Reboot and let NT find the ports again.
That's my 2 cents.....Jeremy
by seadogs
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
0 helpful
1 reply
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies