Discussion Locked

SERIAL PORT BUSY, CAMERA WON'T CONNECT

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hav PIII, WIN98, pc bout 2 1/2 years old. WinModem went bad and replaced with serial exter modem, didn't see USB. Had 2 dif ser cameras hooked to the two ser ports. Can't get 1 of ports to work. Hav to use same port changing cables to use camera or modem. Says busy or not hooked up on other port. EASY FIX??? I'm pretty stupid so make it simple.

7 replies

by wydk/vastech, inc.

Best estimate of this situation not being able to put my hands on the PC itself is to 1) start with your CMOS settings (BIOS) and make sure your serial ports are both enabled. 2) In the Device Manager in Win98, (hold Windows Key then PAUSE key or right click My Computer and select PROPERTIES) and check out your ports - make sure there are no conflicts. Remove ALL of them and let Windows reinstall them and make sure it reboots, if you have to do it yourself should Win98 not prompt you. Aside from that - its the port itself physically and in need of repair - check the pins, straigten any bent ones carefully, but that is probably not it. Try the first two options there; your Win98 drivers will reinstall and you should be ok.

by marcask

You did not mention weather or not you physically removed the internal modem from the machine or not. If you havent done so, remove it. Then go to device manager and insure the modemm does not appear in the device list. Winmodems will normally be listed under modems and a "HCFMODEM". This is the modem enumerator and it does use computer resources. While you are in there, check to see how many serial ports windows thinks it has. If only one, then go to BIOS and see if it is enabled. Also check to see if another program is capturing the serial port on startup. If so run msconfig and disable the program's autostart. Hope this helps.

by shaung411

As a third attempt at this problem, you could try the add new hardware wizard & see if it picks up any ports that were not there before. That could be the reason why both cameras don't work. Other than that just check out the ports in device manager & make sure ther are no conflicts & make sure there are 2 of them. Lastly, check the bios and make sure you have 2 external serial enabled. Most bios' only have one external serial port & one internal port on by default.

This discussion is closed to new replies.