Discussion Locked

server NIC drivers

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Compaq 4500 running NetWare 4.01. The server was downed, unplugged and brought back up. At that point, the AUTOEXEC.NCF was missing. I had a backup of it and typed it in word for word like it was before and rebooted. Now the server comes backup, but The lan drivers are missing. I ran INSTALL.NLM and tried to set up the NIC drivers, but they will not load properly and they still don't showup under the LAN INFORMATON option of MONITOR. What am I forgeting to do?

5 replies

by jimbb

Why do they not load properly? Probably messages like "cannot find public symbol..:" or so. Check your disketts/cd, there's most likely a folder with NW4-specific files that need to be copied too (things like ETHERTSM.NLM or MSM.NLM or so), and need to be loaded first, or auto-loaded by your LAN-drivers.

Just a thought - if both LAN drivers and autoexec.ncf are missing, do you still have a SYS volume? If not, I suggest you first check why that doesn't mount, maybe the LAN-issue will fix itself after that, since drivers and autoexec.ncf reside on that.

Jim

by tbradley

Look at your autoexec.ncf again.

If there is a # in front of the lines which
control your lan drivers.... ie

#bind IP to e100b_lan etc etc

then the Lan drivers have been sent to
autoload in your Inetcfg file.

Remove the # and reboot. You can also try
loading inetcfg to see if they exist there.

This discussion is closed to new replies.