Discussion Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have 5 novell servers i our network among othe NT servers. Our main server is set for the time sync server and updates the other servers. However, the main server looses time, maybe 7 min. over a 2 month period. What could be causing that?
6 replies
by rbgnr111
it may just be that it's hardware clock is slow.
either through monitor or by editing the timesync.cfg you can set an ntp time source to provide time for your network.
Thank you.
Dave, thanks for the suggestion. What is the actual line command for the timesync.cfg file?
by jimbb
To use NTP, do the following in Monitor|Server Parameters|Time:
-Set configured sources=on
-in Sources, fill in the IP of an NTP server (check any www search engine, you'll find sufficient) using the following format: xx.xx.xx.xx:123; (where xx.xx.xx.xx is the NTP server's IP address). UPD port 123 must be open on your firewall to allow for the timesync polling and answering.
Jim
Thanks for the answers. This will help.
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies