Discussion Locked

Server Time Synchronisation for Win 2000

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Dear all,

I've problem with the above and I hope that you can help me here...

The problem us my PDC FSMO's time, which hold the time source, is different from the Internet NTP servers by four minutes. I've tried to use the net time command to sync it but it's unsuccessful.

Is there any way that I can sync the time without rebooting the server?

Thanks.

Best regards,
Michael

2 replies

by trleelaboy

At a command prompt type:
net time /setsntp:
Replace with the IP address of the NTP time server you are trying to synch with. Then, still at the command prompt, type the following commands in this exact sequence, and hit enter after each command:

w32tm -tz
w32tm -adj
w32tm -adjoff
w32tm -s

This series of commands is needed to work-around a known issue with the time synchronization (port contention issue) in W2K. If you follow all of these steps and your W2K DC has a connection to the internet, it will automatically synch the time every 8 hours or as frequent as every 45 minutes depending upon how far your clock is "off."

Good luck.

by entaro

Hi lee_laboy,

The DC gets its time from a local firewall which in turns take the time from a NTP time server. The firewall time is correct but the DC time is 4 mins faster.

Can I use your command to sync the time of the DC with the firewall?

Thanks.

This discussion is closed to new replies.