Discussion Locked

Service Monitoring Software

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Does anyone know of some sort of service monitoring software that I can use to send me a page when a services stops. In other words, there is software out there like SmartUPS that sends a signal through the serial port to a server that can send a page to a numeric pager via a modem when the UPS is running on battery. I'm looking for something that we'll send me a page on my cell phone when a service fails or is stopped, like say Exchange IMS.

5 replies

by erikdr

Answers will vary between 500-dollar building blocks and total solutions costing 100 times more than that. Take care that most notification/paging utilities are _meant_ as building blocks on top of frameworks like Aprisma Spectrum, HP OpenView or BMC Patrol but some of them could be used standalone.
Again for the detection of the stopped service, the blocks vary. In your case it might even be enough to add the WMI layer for NT Server (free from MS) and poll the services regularly with a self-written WMI script. That script could finally call the paging tool.
For finding that paging tool which can be used standalone, I'd recommend browsing through the third-party catalogs of the three leading management building block vendors mentioned (aprisma.com, bmc.com and openview.hp.com). You'll even find third party products which fit into more than one framework!

Have fun,

/ The Netherlands

by jason

A good User friendly service monitoring software I've used is called WatchDog. You can setup this software to page you if anything goes wrong as well.

This discussion is closed to new replies.