Discussion Locked

service pack 5 for netware 5.... did not

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i applied service pack 5 on my novell 5 server. 3/4ths through, it ask for username and password. i put the admins password who has rights to all, and it said i didn not have rights. i put in a few other users who had suppervisor rights. i finally was able to escape out past this and the patch continued. but when the server was rebooted it seemed to load well. when i signed in at my station as admin, i wasnt able to get the mappings, but was able to browse the server. i could not use nwamin, could not run any network apps. spent about 4 hour trying to fix this, and spent about 20 minutes uninstalling. has anyone seen anything like this or have any suggestions?

5 replies

by papachuck

I have run into this twice on a Netware 5.1 server and sp1. I found when I try to install the service pack from a remote machine (C: drive or another server) the NDS can get confused and not allow a login. This corrupts the NDS on that server causing no login's, volumes, or other objects to work. When I copied the sp1 to the sys volume it installed correctly and found the login. Be sure to run dsrepair before a upgrade so there are no errors in NDS. Hope this helps. Chuck

by robert

I run in to the same issue for a couple of days ago. I get stuck when Support Pack 5 asked for the User and password. I first tried all the usually naming stuff (Fully distinguish name, typefull, typeless..) but i still couldn’t login. I solved it by looking at what the nw5sp5 was trying to accomplish. It was caught when it tried to update the schema for NDPS. So i aborted the nw5sp5 installation and update the schema thru nwconfig instead
at the console started nwconfig - Directory options - Extend Schema-login (here I could login)-point to the schema-file at SYS:NW5SP5\PRODUCTS\NDPS\SYSTEM\SCHEMA\NDPS201.SCH ( if you extract the NW5SP5.EXE at the root of sys:)
Then I rerun support pack 5 it still asked for a user/password but because the right schema already was in place it gone true and completed the installation.

This discussion is closed to new replies.