Discussion Locked

service pack 5 for netware 5.... did not

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i applied service pack 5 on my novell 5 server. 3/4ths through, it ask for username and password. i put the admins password who has rights to all, and it said i didn not have rights. i put in a few other users who had suppervisor rights. i finally was able to escape out past this and the patch continued. but when the server was rebooted it seemed to load well. when i signed in at my station as admin, i wasnt able to get the mappings, but was able to browse the server. i could not use nwamin, could not run any network apps. spent about 4 hour trying to fix this, and spent about 20 minutes uninstalling. has anyone seen anything like this or have any suggestions?

7 replies

by gkeel

Although I haven't seen the results you have, I have seen the problem with not accepting the admin user and password. You have to use the admin's user FDN (fully distinguished name) to get the login. I usually use cn=username.ou=orgunit.o=org version just to be sure.

by wayne

Although I have not seen this before I would suggest that you backout the SP5 install, from NWCONFIG, then and reapply SP4, paying special attention to the NLS install. (This is where you were prompted for the admin login.) After SP4 is in, I wouldbegin a detailed inspection of DS and rights. A hunch says you'll find problems that even DSREPAIR won't show. Get things squared away and decide whether to try it again.

After about 20 installs of SP5 I have yet to encounter any type of installation problem so hopefully your next time will be the same.

by quija

I had the problem logging in as admin--even using a distinguished login. I made my personal ID equivalent to admin, and then logged in as myself (distinguished login.) It worked. I ran dsrepair the next time BEFORE I did a server upgrade, and I logged in as admin without issue.

You are asked to login during the license installation. Check to be sure your licensing is operating correctly.

Be sure to read all TIDs on removal of a service pack before you begin! I've ended up with worseproblems removing the service pack.

This discussion is closed to new replies.