8 replies
by calves
Well, without using VPN your cost will go skyhigh. ATT has such product for sell. It links offices accross a fast connection like T1s.
What I have done is a combination of free technologies that works well.
First, on each office you should have a BDC of your network as well as a segment of the same subnet of your network.
On each BDC as well as in on at the main office, you install Routing and Remote Access Server from Microsoft. It replaces your RAS Server software and adds routing capabilities. Then you add PPTP protocol with at least 5 VPN channels.
Now, you program each RRAS to route your network, adding routes to each network. You also setup the RRAS to connect each office to each other using your local Fast Internet connection.That is all! You'll have a fast reliable WAN at the least cost.
Check out my Web site at www.softsolutionsconsult.com - network I have info on RRAS and VPN similar to what I just discussed.
Good Luck!
by compjay
by mcessna
by compjay
A VPN is the way to go. WatchGuard Technologies puts out a relatively inexpensive VPN solution that is very robust and offers security as well. It is PPTP and IPSec compatible. You can implement one of their Firebox II routers (appx. $4000) at the home site (where the PDC is) and their FireBox SOHO VPN solution (appx. $750) at each remote site. It allows for full, protected communication between all sites as if they were on one big LAN. It is VERY easy to configure and almost maintenance free. Check out this link for more info of the product:
by compjay
by mckaytech
Calve's answer assumes you will have a server in each office. From my reading of your question, you will have just workstations and printers.
If my reading is correct, you just need a router at each branch office with a LAN connection on one side and an appropriate WAN connection (v.35 to CSU, ethernet to ADSL modem, whatever) on the other. The purpose of the router is to keep the local traffic local and send only the WAN traffic over the WAN. Cisco's 2500 series router is nice but pricey; Intel, 3Com, Linksys and others make routers of varying capabilities and prices. Or for the price of a spare 486 with 12meg of RAM and no hard drive, you can build a Linux-based router.
Then it's just a matter of making sure you have good name resolution and you're up and running.
Incidentally, although I disagree with Calve's answer in this case, his site is an EXCELLENT reference for inter-office networking and well worth a look.
paul
by compjay
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending