Discussion Locked

Setting Up Network Address Translation

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,
I have a question about how to setup NAT using Cisco Routers. Here is the situation. I have multiple Dealer Sites. Each site has multiple users. Each of there networks have their own set of IP address's. They could be the same, I don't know. We want each dealer to be able to come into our DMZ through a firewall. We are going to be using Cisco Routers and we are in the Process of purchasing a couple of 1720 to do some low end testing. My question is, How would we go about doing this. Would we need to Translate on the dealers end and then again on our end? Does it need to be a dynamic change, or do we need to set up a Static Translation? Is there a diagram out there that shows how this would work, with multiple remotes coming into one host using NAT??
I know this is a lot of questions, but I hope this makes sense.

Thank you for your time
Kevin

5 replies

by lacy.jeff

What I have done is set up NAT at the remote site with their Ethernet as the outside NAT and the connection (Frame/Relay in this case)
as the inside NAT. I then set ip a NAT pool of addresses in a range large enough to cover all of the users for that site.

by gbjoe

Will the dealers connect from their private (internal) LAN, through the net to your DMZ ? Or are the communications through private or dedicated lines ? Will your site's internal network need to communicate with the dealers internal network ?

Now I'll assume the communication will be from from the dealer's internal network to your public DMZ (seen on the internet).

You will NAT at both ends but only to hide the dealer's internal network and to hide your and the dealer's firewall IP.

From the dealers side:
any internal address ---> public address (one other than the firewall's address)

From your end:
any internal address ---> public address (one other than the firewall's address)

No address translation should be done for the addresses in your DMZ.

Hope this helps

This discussion is closed to new replies.