Discussion Locked

Setup form printing in NDS

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a client that prints many differnt forms from one printer, they would like to use the form option in NDS printing. Here is the question can the form option be setup to notify the user to change to a different form. The client seems to think we can set up forms printing for each differnt form they print and notify the user when to change the form in the printer.

Can anyone help ?

5 replies

by rmacbeth

If you are useing queue base printing all you will have to do is go into the detail section of your printer object and on the printer configuration tab under the section: CHANGE MODE FOR FORMS pick CHANGE FORMS AS NEEDED. Then on the Notification tab make sure that you check : NOTIFY PRINT JOB OWNER. This should notify the print job owner that a form chnage is needed if the wrong form is loaded.

This discussion is closed to new replies.