Discussion Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a client with a Compaq Proliant 1600. Recently I went to upgrade the tape backup and removed an older adaptec scsi adapter and replaced it with an adaptec 29160. whenever the ham driver is loaded the server eventually abends with a cpu hog server 02 process. I have upgraded all firmware and have service pack 8a installed. all applicable compaq patches are installed and I am using the latest adpt160.ham driver. I have used NWASPI 2.0 and later versions. I have positioned the driver to be loaded in all possible places in the startup.ncf. I have swapped out cards, turned off the bios load. the only thing attached to the card is the tape drive. The abend occurs with nothing attached to the card. WHAT ELSE CAN I DO?
6 replies
The adaptec driver I am using is 15.03 (from the Compaq NSSD set)
by matkinson
The card is known to work with NetWare, and I'm pretty darn sure there's nothing weird about Proliant 1600s that would keep Adaptec SCSI drivers from working. You've done all the troubleshooting steps for this that I can think of save one:
Swap out the card.
You may have bad hardware on the card itself.
I did swap out the card (stated in my original question)
by scott
I have the same thing with the adaptec aic78u2 drivers. Disable auto pci in the pc bios setup, give it a manual IRQ, and set the SCSI configuration NOT to enable large disks, let Novell take care of it. Works for me.
what it came down to was that the proliant 1600 needs the smart 2sl raid card and the 29160 on the same bus, either primary (slots 1 -3) or secondary (slots 4 - 6). just one of those flukey hardware things.
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies