Discussion Locked

SHIVA Connection Error 651

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Some of our users calling via outside lines to a SHIVA system are getting an "ERROR 651" hardware error. Does anyone have any information about this error? I have checked MSKB, IBM knowledgebase, Xircom, SHIVA, USR/3COM and cannot find squat about"Error 651". The error is driving us nuts because it prevents remote users from connecting. HELP!!!

We know that the modems are working. They have tested out OK. We can connect through a PBX number w/o problem, but outside lines yield "error 651". Not all users are affected, but those that are consistently get the error. If you can help (and I can provide you with more details), you will get the 1000 points.

7 replies

by ann777

If you do a search in MS Knowledge base (for error 651 in all ms products), you will find 15 technical notes. Most having to do with RAS.

Q162594:
"The very low network bandwidth being used is insufficient to host the complex protocols employed to achieve Microsoft networking. The low bandwidth is further eroded as peer entities in all the protocol stacks being used time out request and initiate their retransmission routines.

The problem ultimately is the low bandwidth of the end-to-end connection, which can be as low as 120 KBps as a result of a mixture of low speed SDLC links between FEPs and other SNA traffic over the same links. SNARAS provides a guaranteed delivery, but RAS "believes" that it is not guaranteed and this level of bandwidth is too low for RAS to use."

Q122414
Suggests that you look at the modem initialization string and modem hardware/software settings for that particluar modem. But if you have time, you might look at that and try the "Hayes Compatible Modem" settings to see if any of those will work.

by msmaerz

We ended up bringing in the OEM vendor to troubleshoot the issue. It has turned out to be multiple areas, including the telco provider lines. There was no one answer and frankly we still do not know what the issue was. It may have been a conglomerattion of problems from each component involved in the system. The "fix" turned out to be a shotgun approach to all systems involved. It is working, but don't aske me why.

by maxwell edison

This error message occurs when RAS cannot correctly communicate with the modem. The COMMAND_INIT string

AT&F &C1 &D2 Q0 V1 \N1 S0=0 S2=128 S7=55

in the MODEM.INF file for the Evercom 24E+ is incorrect.

To correct this problem, use the Hayes Compatible 2400 selection instead of the Evercom 24E+ selection in the RAS Setup

Maxwell

This discussion is closed to new replies.