Discussion Locked

Simple Little Network Needed

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I need to create a simple network, to network about 3 or 4 computers together. They connect to the internet via DSL but have only one connection. Its only a small company. What do you suggest to set up a simple network for these computers to share information and utilising the DSL at the same time to connect to the internet. It has to be fairly cheap because the company is only new.

13 replies

by poettone

You didnt happen to mention the operating systems used. If they are Win98se then install Internet connection sharing, through add remove programs and windows setup and internet options. this will only be available with 98 second edition. If that isnt an option you could install a hub and identify the connected pc as the gateway pc to the others for access.

by shmaltz

if all the computers are win9x then only if you have win98se you can use internet sharing.
if the computer connected to the DSL is not win98se and not winnt (but some other version of windows) then you will have to network all the computers and forthe one connected to the internet you will need a program to enable proxy on that computer and set up all other computers that want to connect to the internet thru that connection to use a proxy server, since winNT is the only windows OS that supports IP forwarding out of the box you cant set up any other windows computer to act as a gateway.
there is a lot of free proxy programs for windows 9x that you can download check out http://download.cnet.com/ and search for "proxy".
the one that i liked the most and its free is sambar server from www.sambar.com.

by servermonkey

If your DSL service uses the Cisco 675c DSL modem, you're in luck, it will do dhcp automatically, all you need to do is connect a hub, run cable to each machine from the hub and your set. If that isn't the case, I would make life easy on myself and get one of the new broadband routers available for as little as $90 or so and connect it to a hub. These routers are a breeze to setup.

Good Luck

by rgrowcock

I have this same situation in my office, even though my network has been getting larger. What we did is get an inexpensive Netgear router and connected the dsl router to it. The Netgear router acts as the dhcp and then it is hooked into a hub. I would advise getting a larger hub than you may need right now to allow for expanding. Don't go over board with the hub, go with what you can afford.
The Netgear router will also allow you to make firewall settings too so you can spoof your internal network to the outside. You would just have to connect the dsl router to the Netgear router and give your ISP the MAC address of the Netgear router as your gateway. All of this can be down for under $250, maybe less depending on you local stores. I use this with Win NT 4.0 and Win9x. Good luck and feel free to email me if you have any questions setting this up. Roger

This discussion is closed to new replies.