Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have just installed a new Dell Dimension 4100/1.3 ghz PC and install Client 3.3. The PC logs into a Netware 5 server (DEll Powerdge 1300/500 mhz)that houses a DOS program. Access to this program from this new PC is very slow yet access from the older, slower PC's that operate on the network is operating fast. Please advise, for I am at a loss.
5 replies
by jimbb
Have you checked the LAN settings of your new workstation: 10/100 Mbps, full/half duplex? Incorrect settings often cause strange slowdowns like this.
Jim
by jtoscano
Poster rated this answer
by rpritt
Check to see which protocol is the preferred protocol. On DOS programs, they usually want to see IPX, so set IPX as the preferred protocol. Also, try manually setting the frame types in the client.
by jtoscano
Poster rated this answer
by scatco
Question - what OS are the workstations running??
What Novell Client are the old workstations on??
I assume from your comment that your Windows programs are running as fast or faster than on the older stations??
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies