Discussion Locked

Slow restore with NW Agent for Arcserve

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Here's my Situation.

I Have Arcserve2000 sp2 installed on a W2K server to backup all my Windows Servers and all my Netware 4.11 & 5.1 Servers with the Netware Client Agent installed . When I backup up my Netware Server with TCP/IP, I average 250MB/min. When I am restoring, I average 6.8MB/min(????). If I restore with IPX, it's 120MB/min (OK). Arcserve said something about Half-duplex, or Bad TCP NLM from Novell. I can't take that as a solution.

Does anyone have an Idea, or ever use Nwagent?

I appreciate,

Jasmin.

6 replies

by curacao_dejavu

I mailed the a document "increasing performance .. although it is in respect to arcserve 6.
Accidently I read on the that site also something regarding slow performance with the novell client software ? (can not find the artickle now)

which version of the novell client are you using ?

regards,

by soundsolutionsinc

Are you receiving any error messages on the Netware console when you are restoring the data? I don't have much experience with NWagent, but it does reak of an IP issue. Check out Novell's support site - support.novell.com - their ArcServe support is better than Cheyenne's.

Extra performance tip: Check out the antivirus situation. Did the tape get scanned for viruses as it was backed up? If so, you don't need antivirus software sniffing the restore on the NT server as well as the Netware server.

This discussion is closed to new replies.