Discussion Locked

Slow server responce

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Slow server response across routed network after install of L3 switch. Routing IPX EIGRP on L3, also have RIP routing as well.

5 replies

by dragon_45

I do not know, but if no one can help here.
Subscribe to The NOVELL list is managed by a LISTSERV server. LISTSERV commands
should
always be sent to the "LISTSERV" address, ie
LISTSERV@LSV.SYR.EDU.
They also have a FAQ report you can download.
I use many different resources!

Good Luck
Richard Bolha
Dragon@one.net

by wcraigmiles

This is not a Novell or NetWare issue.

Are you propagating RIP routes into EIGRP? I think you need to set RIP on the switch to passive interface.

Check to see if you have mismatched frame sizes. Try disabling RIP. Look at any ACL's that areenabled on this box.

Are you using the nofragment setting?

by kboehs

It did turn out to not be a Novell issue, it was an issue with auto port settings between a 3com 3000 switch and the Cisco L3. Both system had to be set at speed 100 duplex full.

This discussion is closed to new replies.