Discussion Locked

Slower Performance

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I have upgraded my netware 4.11 server to 5.1.But the performance is drastically degraded as compared to 4.11.Utilisation is very high and performance too.I'm using compaq proliant 3000,1gb RAM,cpqnf3 lan driver.
Could you suggest some guidelines on this.

Thanks
Sanja

9 replies

by avmw

Hi

you can try removing java components and other unwanted java applets from server try
unloading startx or reconfigure it and check the response beacause this gui is carving memory and u can do one more thing see module information and mem statistics through monitor

try this out

by sanja.das

I have aleady unload the relevent Java components.There is no such difference in Utilisation.

by estebandelatorre

Pure IP?
NW 5.x works better than 4.11 (but ip only!)

Another: Did you wrote down those "SET parameters" that you have carefully being tunning during years???
Ok, sometimes one of those parameters goes back to it's default value. Check Them Twice!
What about the File System? did you upgrade volumes to NSS?

edt@bancobgn.com

by colin_joseph

Ok...first things first. The main tool you need to use is monitor. If you can afford to, use the purge /all command at the root of each volume to remove all salvage files. Make sure that you back up the server entirely, first, though. Performance problems are related to unpurged files. The next thing you have to do is go into monitor and then Kernel and then Threads. This will tell you the most active threads on the server and what is causing the utilization problem. Use the clear workstation all command and see if once you clear all connections, does the performance issue continue. Big file copies to or from the server will create a utilization spike. Go under nwconfig and check the autoexec.ncf files. Make sure every command isattached to a package and that unneccesary NLM's are not being run. Last but not least,... comment out the startx command from autoexec.ncf, because java is a big consumer of memory AND processor.

This discussion is closed to new replies.