Discussion Locked

Slow,slow backups w/Arcserve 6.5

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Dell 2400 running Netware 5.0, Archive Python DDS3 tape drive, 27GB RAID 5 array and Arcserve 6.5. My backups start out slow and go down hill from there. I come in the next morning and try to kill the running job and the server abends. I've tried Novell's and Arcserve's troubleshooting tips but cannot pinpoint the problem. I even got Dell to replace the tape drive but that wasn't the problem. Any ideas?

15 replies

by haggis

Sounds like it could be a lack of Directory Cache buffers, ,which netware uses to cache all data coming into disk, or for read-ahead of data coming out of disk. Make sure there is no bottleneck there. I've also experienced problems with some DLT's, in particular the Compaq 20/40's, where backups will run like a dog unless a special TAPESRV.CFG is used. It'e worth checking the CAI or Dell support sites for any possible technotes regarding DAT's.

by duster52

I agree with answer #1. We experienced the same problem with a number of servers....when we up the Directory Cache Buffers (both min and max) the problem went away. I noted the currect min and max values, then watched the DCBs. When the DCBs exceeded the min value by a significant amount, I increased the min to the new value and increased the max by a coresponding value. I kept doing this until everything seemed to stabilize.

Also, what other applications/functions are running on the server? How many replicas (we have seen this cause a problem)? Sometimes other apps will such up resources....

by golfkinguk

Add the lines :

[CONFIG]
BUFFER=20

in the tapeserv.cfg located in the nlm directory. Add it right after the [nlm] section.

The only time I had the EXACT same problem,(transfers started at a rather slow rate, then dwindled to nothing and failed with media related messages), it was a bad Compaq tape drive(it happened twice). However, this setting will speed up your transfers.

by sleeper

1. I might be wrong, but is there an ArcServe 6.5? I thought it went from 6.1 to IT6.6.
latest sp for asIT6.6 is sp4 - check/reply on this.
2. check the version o/t tsands.nlm and try up/downgrading to c if that helps
3. sp5 for nw5.0 is out - try that one

by sleeper

1. I might be wrong, but is there an ArcServe 6.5? I thought it went from 6.1 to IT6.6.
latest sp for asIT6.6 is sp4 - check/reply on this.
2. check the version o/t tsands.nlm and try up/downgrading to c if that helps
3. sp5 for nw5.0 is out - try that one
4. all volumes have the same problem?

by dyeager

Given minimal details, here are two possibilities:

1) add more memory, With Netware 5 and arcserve I would like to see at least 256MB. Close you xconsole as short term fix.

2) make certain compressed files are not being expanded to backup server.

by taterater

If you have directories with large numbers of small files check out http://support.novell.com and search on Novell TID 1005590.

This has the directory cache settings above but also some more sttings that might be usefull

This discussion is closed to new replies.