Discussion Locked

SMDR Errors

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am new to this sight so forgive if I do something incorrect. I have a 411 server that was doing backups for itself and 2 other netware 5 servers. No problems. However, because I was also running GroupWise PO on that server, we moved the backup to one of the 5.0 servers. Now I cannot get SMDR to load on the 4 so that I can backup my PO. The log reads as follows

NDS Context: OU=Labs.OU=UC.O=SU
NetDB Library loaded successfully.
SERVER-4.11-1586: Loader cannot find public symbol: WSAStartup
SERVER-4.11-1586: Loader cannot find public symbol: WSACleanup
SERVER-4.11-1586: Loader cannot find public symbol: WSAGetLastError
SERVER-4.11-1586: Loader cannot find public symbol: WSAInstallServiceClassA
SERVER-4.11-1586: Loader cannot find public symbol: WSARemoveServiceClass
SERVER-4.11-1586: Loader cannot find public symbol: WSALookupServiceBeginA
SERVER-4.11-1586: Loader cannot find public symbol: WSALookupServiceNextA
SERVER-4.11-1586: Loader cannot find public symbol: WSALookupServiceEnd
SERVER-4.11-1586: Loader cannot find public symbol: WSASetServiceA
SERVER-4.11-1586: Loader cannot find public symbol: WS2_32_htons
SERVER-4.11-1586: Loader cannot find public symbol: WS2_32_inet_addr
SERVER-4.11-1548: Load filereferenced undefined public variable.
Module SMDR.NLM NOT loaded

Help

5 replies

by acurrin

Public symbol messages are related to an underlying support file that is the wrong version. Service packs are a good place to start.

But - if the backup is running from another server, you should be using the Target Service Agent to connect to the remote server.

Find the TSA file in the system directory and load the NLM at the server. It should be

server:load tsa410

If you are using ARCserve or BackupExec, consider using their GroupWise agents to backup the PO that way open files will be backed up.

by rbayne

Found out that the Arcserve software loaded the Netware 5 SMDR. restored the original back from tape and am in business. Thanks for the help.

by papachuck

also try to reset the SMDR. Type SMDR NEW at the command prompt and it will ask you a few questions and rebuild your SMDR options.

Also apply the latest 4.11 patch like the above message says to get the current SMDR files......Good Luck...Chuck

This discussion is closed to new replies.