Networks

Ask something
Discussion Locked

Snap Back 4.11

0 helpful
3 replies

by cdobbin 1 view

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a very perplexing problem. I installed the snapback client on a win95 machine, when I start the client I get a error message "C is not a valid integer value". I reinstalled 95 and installed the client once again with the same results. After Iclear the error the program opens but does not prompt me to log into the server, so I can see no partitions or tape drives. The server is novell 4.10 and the snapback engine appears fine. The connection between the pc and the server is fine. This has got me stumped and not sure what to do next, has anybody ever seen this or heard of it, I have already e-mailed snapback and they have never heard of this error.

3 replies

by cdobbin

I failed to mention that I have already tried re-installing the engine on the server and got the same results.

by estebandelatorre

If you can't get enough support from your dealer, it's time to change your software. Consider Arcserve, on of the best ones for netware.

by cdobbin

we have over 200 sites using Snap Back, we never had any problems getting support from snap back, it was only this one problem in particular that seemed to give them any problem's providing support for us. The problem is long gone and we did haveto go with another backup solution for this site.

This discussion is closed to new replies.