Discussion Locked

SOHO Network - Can't see each other...

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have cable internet and two computers connected via a D-Link Hub. It all worked fine once upon a time but now, neither computer can see each other unless the "Find Computer" utility is used. Without using this the drives cannot be mapped and regardless, the "other" computer is never visible in the Network Neighbourhood folder.

I am using both TCP/IP and IPX protocols and the domain names are identical. It all used to worked perfectly. (WIN 98SE two Pentium C400's, 2 NIC's and one hub)

7 replies

by rogueldr

I would first check to make sure that the pc's are in the same subnet. You could click on Start, Run, type winipcfg in the dialog box and click ok. You may need to use the pull down menu to see the NIC IP, normally the PPP Adapter setting is default.
If the IP's are within the same subnet then add NetBEUI protocol which is good for resolving names across a small peer-to-peer network.
A typical IP range for a local peer-to-peer would be 192.168.x.x Some cable providers however will assign an IP to you pc through DHCP. This has happened to a couple of my customers without them realizing it. The pc that the cable modem attached has an IP within the cable company's subnet and their second PC still has a static IP that they themselves assigned. There are several Hubs out now that are made for cable access that also have internal DHCP server included that will serve out IP addresses to your entire peer-to-peer.

by Former member

Funky Network Neighborhood never works right, I don't know why people bother...What do you really need it for? Do without....

If you really want to see that other PC in the NN, then add the netbeui protocol...

by des

A "missing" Netbeui protocol was the problem. Unfortunately the first response made this suggestion so that answer was accepted first. Thank you all the same!

by p. dickason, cne, mcse, cca

Hi,
Check your Workgroup under Identification in network settings. This needs to be the same as the domain name set at client for microsoft networks. If this is not set, you will not see other hosts within the domain.
Hope this helps
Pete

by des

I had already explained that the domain names were checked and identical. Thank you for trying all the same.

This discussion is closed to new replies.