Question Locked

Solved - Back-To-Back Router Configuration for WAN Test Lab

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi all,

Currently, I have a 2821 with an HWIC that is a 2 port E1 or T1/PRI card. A show ver shows this is recognized but I don't see it in the interface configuration selections. If I could find the interface then I could configure it! Any help on how to get started with this project will be greatly appreciated. I'm doing self-study and wanna simulate a WAN but this problem is holding it back. /sadface

Thanks in advance,

Chris

4 replies

by souptoi

The card type was disabled. You can't enable it in interfaces.

To enable it, go to configuration terminal enter the following command:

card type e1 | t1 0-2 0-3

problem solved :)

by michael kassner

I was wondering if you were in the GUI or CL. I suggest working in the command line mode exclusively it will give you less headaches. Show int ip brief would have pointed that out to you right away.

This discussion is closed to new replies.