Discussion Locked

Sound problem with new HDD

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Sound Blaster Live, 10GB HDD running at 5400rpm and everything was 100% until I installed a new 17 GB HDD running at 7200rpm (not sure about the exact rpm there - but I know it is definately faster).

Now, whenever I play sound from this new HDD (games, mp3's etc.) I get funny noises. The sound the disc makes when it reads/writes data is not supposed to be heard, right, but it seems as if it is amplified through the sound card. That is why I am hearing it through my speakers.

Any ideas on what might be causing this?
I doubt strongly that it's software.

7 replies

by bobho

VIA has documented this problem previously as a problem with the Live! card not conforming to PCI bus standards and thus picking up sounds off the PCI bus (see http://www.viaarena.com/?PageID=26). If you have a VIA motherboard they have a patch for the SoundBlaster sound cards. If you have a different motherboard see if the manufacturer of your particular board has a bios patch for SoundBlaster cards.

Good luck.

by shanghai sam

Yes, I have a VIA Apollo Pro 133A (GA-6VXC7-4X) motherboard. This patch you refer to, is it their 4in1 driver? If it is, I downloaded the latest one and installed it but after I restarted my PC I thought it was gone until I tested it like this: WhenI listened to an MP3 while copying from the new HDD to the older one or vice versa it still gave me crackling noises.

I am going throught the forums on VIArena's site (thanks for that URL) but so far nothing is helping. Someone said that one should install that 4in1 drivers in safe mode - haven't tried that yet. So far no one has really found a definate sollution.

Thanks again - you put me on the right track.

by damjef

these points are just for info really but i hope they help, i've dealt with several problems relating to the 5.1, it may well be the software application for the card, try reinstalling the application cd, i've dealt with instances whereby the cd hasn't installed properley, secondly it could be discharge from the h/d, if your cable is long enough try running it out of the case,covers for hard drive discharge are available(also its worth bearing in mind that with ME udma66 carries the sound data so the need for the 4 pin cd connectors not required) try a new quality udma66 cable, failing that you could have a faulty drive. is your onboard sound disabled? hope this helps.

by shanghai sam

I don't have the SBL 5.1, I only have the normal "Live!" - as far as i know anyway - one can always be mistaken.

I did reinstall the CD that came with the sound card - same thing.

My motherboard's onboard sound is disabled.

I will keep the IDE cable and UDMA66 issue in mind if I don't come right with anything else.

Thanks for the reply.

by shanghai sam

Windows 98 SE, Motherboard: GA-6VXC-4X VIA Apollo Pro 133A Chipset.

Hope this gives a clearer picture.

by nols

To: bilbobagginsesq@hotmail.com

I have put this 17GB HDD on a new IDE cable with my primary HDD. My sound problem is solved.

Thanks - I should have given you that 150 points.

This discussion is closed to new replies.