Discussion Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Sprint is hosting my MPLS connection. I have a my cisco routers in 2 cities. Each one will connect to Sprint routers hosting the MPLS service. it is my understanding that little MPLS configuration is needed on my equipment. However, I cannot get the tunnel to an UP/UP state. Can anyone offer config advice or terminology to use to help me seek a solution?
2 replies
by fregeus
Are you talking about you needing help in configuring the CE router? If so, contact Sprint, it is included in their services to help you configure that router, if they don't configure it themselves.
Are you talking about you needing help in configuring a router that will go in front of the CE router? If so, there is no MPLS configuration needed. That is a strict Ethernet configuration between two routers.
TCB
by obrien2013
That's what I thought. however, the protocol will not go up.
Wierd
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies