Discussion Locked

SPX Establish Connection Table is Full

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When I try to Rconsole to a Netware 4.11 server from a Windows NT 4.0 PC I get the following error message while i'm in Rconsole 'SPX Establish Connection Table is Full ' and I'm unable to connect to my NetWare Server .

7 replies

by garym

Check on your workstation to see whether you have a NET.CFG file. If so, remove the SPX= entry in this file.
Gary

by lcd4

Symptom
When attempting to create an SPX connection with a server across a WAN (whether using RCONSOLE, print services, etc.), the following error is returned: "SPXEstablishConnection failed to establish a connection to the desired server....the server connection was terminated by AllocateConnection".

--------------------------------------------------------------------------------
Cause
We got a trace from the segment that fails and verified that no response was received for the SPX connection request. Just one hop closer to the destination server, SPX connections were established with no problems. Suspect was a duplicate network address but all IPX communications were working fine.

--------------------------------------------------------------------------------
Solutions
A duplicate external net address was found so that the destination server was responding to the SPX connection request using from its RIP table the best route back to the originator's network address, which in this ca

by thelordoflight

It's your routers. Our WAN group tried to tell us it was a workstation issue, but we are able to connect to other servers without any problem after getting this message.

This discussion is closed to new replies.