Discussion Locked

"STOP" ON WINDOWS NT 4.0 WORKSTATION

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I GOT A "STOP" MESSAGE AT A BLUE SCREEN DURING STARTING MY WINDOWS NT 4.0 WORKSTATION PROFESSIONAL AP200 WITH DUAL MONITOR. THE MESSAGE IS HALTING MY MACHINE FROM FURTHER BOOTING. THE MESSAGE SAYS " STOP:C0000263 {DRIVER ENTRY POINT NOT FOUND}. The \SystemRoot\System32\drivers\dlc.sys device driver could not locate the entry point MmUserProbeAddress in driver ntoskernel.exe."
I re-installed the operating system. But when the machine boots it still stuck on the same place with similar message. I am desparately in need of a solution as my machine contain vital data.

5 replies

by sfo farmer

What was done to this before the BSOD started- what changed? Any hardware or software added? I would do a parallel install of WinNT ( with a no-net config) after removing any new hardware, in particular the NIC. (If your machine has more than one nic: remove the pci nic and/or disable the integrated NIC). See technet Q175767. I had a simlar problem when I installed a second network anylyzer package that installed a 2nd service. If the second NT install works- get your data and run... if not, depending how "vital" the data is, try a recovery service- there are a few good ones out there. G'Luck!

This discussion is closed to new replies.