9 replies
by syscokid
I've seen this a lot and the reasons vary greatly. You don't give much info, so check these resources starting from the top and see if any help you:
http://www.generation.net/~hleboeuf/suwin.htm
http://www.geocities.com/Athens/Troy/6883/suwin.html
http://compguystechweb.com/troubleshooting/windows/suwin.html
http://support.microsoft.com/support/kb/articles/q187/2/68.asp
http://support.microsoft.com/support/kb/articles/Q232/9/63.ASP
by ace_zapper
by calves
A couple tips for you:
http://support.microsoft.com/support/kb/articles/Q187/2/68.ASP
http://support.microsoft.com/support/kb/articles/Q188/1/07.ASP
My suggestion to you is this:
Get a Win98 Startup disk:
Boot from the diskette and run the following commands in order:
fdisk /mbr
fdisk --> delete all the partitions.
Esc until prompt and reboot using the diskette.
fdisk /mbr
fdisk accept all the defaults and select 1 and accept all the defaults.
Once done, Esc to prompt and reboot, go into the Bios and select Boot sequence CD first, insert 98Cd into the CDR tray and reboot. Win98 Setup will take care of the formatting.
Good luck!
by ace_zapper
by agent_
If this is the error you receive I hope this helps you..
Application Error
SUWIN caused a General Protection Fault in module PIDGEN.DLL @ 0001:5F2C
MSGSRV32 caused an General Protection Fault in PIDGEN.DLL
SUWIN Error in Pidgen.dll During Windows 98 Setup
--------------------------------------------------------------------------------
The information in this article applies to:
Microsoft Windows 98
--------------------------------------------------------------------------------
SYMPTOMS
When you install Windows 98, you may receive the following error message when you type your Product Key and then click OK:
Application Error
SUWIN caused a General Protection Fault in module PIDGEN.DLL @ 0001:5F2C
MSGSRV32 caused an General Protection Fault in PIDGEN.DLL
This behavior may also occur if you start your computer with a Windows 98 Startup disk and then try to install Windows 98 from CD-ROM, or if you attempt to view your hardware configuration using the System Informatio
by ace_zapper
by philip
What I can suggest is you to this:
1 - format the HDD, then start the PC with startup disk (from Win 98 - I think you'll use FAT 32)
2 - use FDISK to remove all partition(s), restart and after that make one (or more if you need)
3 - format the new partition(s), restart and make the disk system by writing this to the command prompt:
A:\sys c:
4 - restart and boot the PC from C:
5 - install Win 98.
You shouldn't get this error again. If you get it, change the HDD and try. If everything is OK, your HDD is damaged. If you get the error again, you HDD is OK, you'd better thange the motherboard.
Hope I helped you
Best regards
Philip (philip@cablebg.net)
by ace_zapper
by amran
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending