Discussion Locked

Switches and Hubs in Wiring Closet

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I inherited a wiring closet with a hodgepodge of switches and hubs. I have the following:

5 - CISCO 2900 series enterprise switches (CISCO 2924C is the main switch wired to the router)
1 - BAYSTACK 350T switch
1 - HUBSTACK SEHI100TX-22 switch
1 - Cabletron FN10
8 - Allied Telesys CentreComm 3624TR Hubs (mounted as 4 pairs)

Grouping of users is not feasible as users work multiprojects and jump from project to project frequently. In the process of buy a new switch each monthto replace the hubs.

I don't fully understand the uplinks on the CISCO 2924XL-EN switches. I see that port 23 & 24 are uplinks. If I plug something into both, it shuts down the users.

What would be the best way to connect the switches and hubs for maximum efficency.
(i.e. connect each lower switch by an uplink to the top switch and connect hubs to switches). How would I use both uplink ports on the CISCO switch.

Is there a good source of information on this. I get lost paging through CISCO.

6 replies

by philando

We use Nortel Networks' Bay hubs and swithches. I know with the BayStacks that connecting two switches requires a cross-over cable. May its the same on the cisco.

by shmaltz

If 2 ports are assigned to one marked uplink, then there is no need for a cross over cable.
In the above configuration you either use port 23 for a regular node and port 24 for an uplink port. When you use port 23 you cannot use port 24, when you use port 24 you cannot use port 23.
To uplink, plug one end of regular cable into the uplink port (24) and the other end to any port on the next Hub/Switch but not port 24 (that is marked uplink, you can however use port 23, but if you use port 23 you will not be able to uplink from that hub/switch.

by shmaltz

The best way to uplink hubs and swithces is by connecting all switches and hubs thru their uplink ports to one switch (because that way the data makes the least hops between hubs or switches).

This discussion is closed to new replies.